Featured £500 depending Speedline wheel 8 1/2 x 17 single wheel pcd 95.25 Car Parts Wanted Davidharvey 14 hours ago Anyone have a single S1 Exige speedline magnesium rear wheel? Any condition, even bent or broken. 8 1/2 x 17 with 95.25 pcd
350 € 4.2 final drive for Rover PG1 gearbox Car Parts Sales rospo41 24 hours ago Trasmissione finale 4.2 per cambio Rover PG1 63/15
Featured £60.00 Inc.Del. Revotec Rad. Fan Controller Car Parts Sales Thor 25th July 2024 Revotec adjustable rad. fan controller, temp. range 70 to 120 deg. complete with silicon top hose, stainless hose clips and E.P. fitting instructions. I bought […]
S1 side coin/ bits tray Car Parts Wanted Norm 77 25th July 2024 Looking for a nice condition S1 coin tray (or whatever they are described as) side of drivers seat.
£75 S2 engine cover Car Parts Sales RossH 25th July 2024 early(?) S2 engine cover slight scratches as was bought and used for making a mould as part for my GRxige project comes with lock (no […]
1.00 Exige S2 2004 parts Car Parts Sales RossH 25th July 2024 Exige S2 parts (2004) ; 11,500 miles when removed from car part numbers are given in good faith and not guaranteed ALL part must go, […]
£30 Lotus Elise S2 wheel bearing – Genuine Lotus OEM part (SKF)- non-sensor type Car Parts Sales big kid 25th July 2024 Lotus part number A117C6002F was working fine – taken off only to replace with a sensor type as I was fitting a traction control system […]
350.00 Nitron NTR Fast Road shocks – S1 Car Parts Sales Scramcannon 25th July 2024 Selling these as a bit of a project. They’re early S1 40mm Nitron shocks, bought about 12 months ago secondhand at the time. Unknown mileage […]
£125 Black anodised S2 dash extrusions Car Parts Sales Mavenl 24th July 2024 A unique set of black anodised dash panels for S2 Elise. I bought this to mount in my car, but decided to go for LHD […]
Less than £100? S1 111s Rear wheel arch spats Car Parts Wanted oliver.postlethwaite 24th July 2024 Looking for S1 111s Rear wheel arch spats. New, used, Original or aftermarket. Or even if you have a CAD model so I can print my […]